10 questions, graded as you go, with the reason for every answer. Start free, no sign-up.
Sample questions
When setting a tree in the planting hole, where should the root flare sit?
About 6 inches below the finished grade
At or slightly above the surrounding finished grade
Well above grade, with the roots exposed
Level with the bottom of the planting hole
Show the answer
B. At or slightly above the surrounding finished grade
The root flare is where the trunk widens into the roots and it should be visible at the surface. Burying it invites bark rot and girdling roots. Setting it far above grade leaves roots to dry out.
Reference: University extension landscape and turfgrass guides (tree planting)
What is the usual guidance for the width and depth of a tree planting hole?
The same width as the root ball and twice as deep
Four times as deep as the root ball and just as wide
Two to three times as wide as the root ball and no deeper than it
Only as wide as the container, at any depth
Show the answer
C. Two to three times as wide as the root ball and no deeper than it
A wide hole lets roots spread into loosened soil, while a hole no deeper than the ball keeps it on firm soil so it cannot settle and bury the root flare. A deep hole with loose backfill is the tempting mistake.
Reference: University extension landscape and turfgrass guides (tree planting)
Where should you make the final cut when removing a side branch from a tree?
Flush against the trunk surface
Several inches out, leaving a stub
Through the middle of the branch collar
Just outside the branch collar
Show the answer
D. Just outside the branch collar
The branch collar holds the tissue that seals the wound, so cutting just outside it leaves the collar intact. A flush cut removes it and a stub leaves dead wood that invites decay.
Reference: University extension landscape and turfgrass guides (pruning cuts)