TradeExamPro

Canadian Working at Heights Practice Test

Practice questions on fall protection and construction safety knowledge in Canada: provincial OHS duties, fall hazards, protection systems, ladders, scaffolds and lifts, and rescue planning.

175 questions · 5 topics · start free, no sign-up

Start practising

Mixed practice test

10 questions, graded as you go, with the reason for every answer. Start free, no sign-up.

Timed mock exam

50 questions in 60 minutes, drawn from every topic. No answers shown until the end, then a score, your weakest topics and a review of what you missed.

Practise by topic

Sample questions

A BC worker will be working 2 m above a pile of upright rebar stakes. Is fall protection required even though the height is under 3 m?

  1. No, because the fall is under 3 m
  2. Yes, impalement risk requires protection
  3. No, because short falls are never injurious
  4. Only if the worker is alone
Show the answer

B. Yes, impalement risk requires protection

BC Part 11 also requires protection for falls under 3 m when the landing hazard makes injury worse than a fall onto a flat surface. Impalement on rebar is that case. The 3 m figure is a general trigger, not an exemption.

Reference: BC OHS Regulation Part 11 (Fall Protection), s. 11.2

Where is the dorsal D-ring on a properly worn harness normally located?

  1. At the hip, on the left side of the body
  2. Between the shoulder blades at mid-back
  3. At the back of the waist, below the belt
  4. At the front of the neck, under the chin
Show the answer

B. Between the shoulder blades at mid-back

The back D-ring sits between the shoulder blades so the body hangs upright after a fall. A D-ring at the waist or hip would fold the worker over.

Reference: CSA Z259 series fall protection standards (principles only) (harness use)

You must work near exposed energized electrical equipment from a portable ladder. Which ladder is the right choice?

  1. Aluminum, because it is the lightest
  2. Aluminum with rubber feet fitted
  3. Fibreglass, or wood with dry rails
  4. Any ladder if you wear rubber boots
Show the answer

C. Fibreglass, or wood with dry rails

A metal ladder gives current a path to ground through you. A fibreglass or dry wood ladder does not conduct well, though it does not replace staying outside the required distance from live parts. Rubber feet or boots are not reliable protection.

Reference: Ontario Reg. 213/91 (Construction Projects), ladder provisions; BC OHS Regulation Part 13 and Part 19

A worker notices a cracked guardrail post on a deck. Under the OHSA, what must the worker do?

  1. Report the hazard to the supervisor or employer
  2. Fix it quietly without telling anyone
  3. Wait for the next committee inspection
  4. Ignore it unless the worker is the one working near it
Show the answer

A. Report the hazard to the supervisor or employer

Workers must report known hazards to the supervisor or employer. Waiting for an inspection leaves others exposed, and repairing it without telling anyone means no one else knows about the defect.

Reference: Ontario Occupational Health and Safety Act (R.S.O. 1990, c. O.1) as in force in 2026, s. 28 (worker duties)

A lanyard is 1.8 m long. Deceleration distance is 1.0 m, D-ring to feet is 1.5 m and the safety margin is 0.6 m. The anchor is level with the D-ring, so free fall equals the lanyard length. What total clear distance in metres is needed below the anchor level?

Answer in m.

Show the answer

4.9 m

Free fall 1.8 + deceleration 1.0 + D-ring to feet 1.5 + margin 0.6 = 4.9 m. Forgetting the margin would give 4.3 m, which is not enough.

Reference: Arithmetic from the stated figures; fall clearance method per manufacturer's instructions

Exams this helps with

ExamWho runs itWhere
Working at heights and construction safety knowledgeProvincesCanada