10 questions, graded as you go, with the reason for every answer. Start free, no sign-up.
Sample questions
Where is the dorsal D-ring on a properly worn harness normally located?
At the hip, on the left side of the body
Between the shoulder blades at mid-back
At the back of the waist, below the belt
At the front of the neck, under the chin
Show the answer
B. Between the shoulder blades at mid-back
The back D-ring sits between the shoulder blades so the body hangs upright after a fall. A D-ring at the waist or hip would fold the worker over.
Reference: CSA Z259 series fall protection standards (principles only) (harness use)
On a site where guardrails, restraint and arrest are all possible, which is the better first choice?
Fall arrest, since every worker wears personal gear
Restraint with a long lanyard to save setup time
Guardrails, since they protect everyone without worker action
A work belt, since it is the quickest to put on
Show the answer
C. Guardrails, since they protect everyone without worker action
Passive, collective protection that works without the worker doing anything is preferred over personal systems that depend on correct use. Fall arrest relies on fit, clearance and anchors all being right.
Reference: Ontario Reg. 213/91 (Construction Projects), fall protection provisions; BC OHS Regulation, Part 11 (Fall Protection) (protection methods)
Where should the chest strap of a harness sit once fitted?
Over the stomach, just above the waist
Across the neck, close under the chin
Under the arms, at the level of the ribs
Across the middle of the chest
Show the answer
D. Across the middle of the chest
A mid-chest strap keeps the shoulder straps on the shoulders in a fall. If it rides low the worker can slip out; if it rides at the neck it can choke.
Reference: CSA Z259 series fall protection standards (principles only) (harness fit)