TradeExamPro

Elevator inspection testing maintenance practice questions

32 questions from the Elevator contractor practice test.

Start practising

Elevator inspection testing maintenance practice test

10 questions, graded as you go, with the reason for every answer. Start free, no sign-up.

Sample questions

A traction elevator is stopped at a floor with passengers inside and a call has come in. What is the mechanic's first priority on arrival?

  1. Make sure the passengers are safe and communicate with them
  2. Open the controller and start measuring voltages
  3. Reset the car and ignore the cause
  4. Remove the governor rope to check it
Show the answer

A. Make sure the passengers are safe and communicate with them

Passenger safety and calm communication come first. Troubleshooting starts only after people are safe, and resetting without finding the cause lets the fault repeat. Removing the governor rope is never a first step.

Reference: ASME A17.1-2025/CSA B44:25, Part 8 (emergency and callback response)

A mechanic needs the car to run while a hoistway door contact is open and places a jumper across the contact. What must happen before leaving the job?

  1. The jumper may stay in place as long as the car runs fine
  2. The jumper is left for the next shift to remove when convenient
  3. The jumper is replaced with a taped wire so it cannot slip
  4. The jumper is removed and the circuit restored to normal
Show the answer

D. The jumper is removed and the circuit restored to normal

Temporary jumpers defeat a safety circuit and must be removed before the unit goes back into service. Leaving one in place, even taped, lets the car run with an open door and can kill someone.

Reference: ASME A17.1-2025/CSA B44:25, Part 8 (safety circuit integrity)

Why is the no-load safety test done with the car empty and the governor tripped by hand or by test?

  1. To weigh the empty car
  2. Verify safeties stop car safely
  3. To adjust the door timing
  4. To reset the car's floor position
Show the answer

B. Verify safeties stop car safely

The no-load test proves the governor trips and the safety grips the guide rails, using the lowest risk condition first. It does not weigh the car, adjust doors or set position.

Reference: ASME A17.1-2025/CSA B44:25, Part 8 (acceptance tests, safety tests)

Other topics