TradeExamPro

Safety devices controls practice questions

32 questions from the Elevator contractor practice test.

Start practising

Safety devices controls practice test

10 questions, graded as you go, with the reason for every answer. Start free, no sign-up.

Sample questions

Under ASME A17.1-2025 (same rule as the 2022 edition), the governor must trip at no less than what percent of the car's rated speed?

  1. 100 percent
  2. 105 percent
  3. 110 percent
  4. 115 percent
Show the answer

D. 115 percent

The minimum governor tripping speed is 115 percent of rated speed, so normal running never trips it. A trip point at or near rated speed would cause nuisance trips.

Reference: ASME A17.1-2025/CSA B44:25 (rule identical in ASME A17.1-2022/CSA B44:22), Section 2.18

A traction car has a rated speed of 350 ft/min. Under ASME A17.1-2025 (same in 2022), the governor tripping speed may be no lower than 115 percent of rated speed. What is the lowest permitted tripping speed?

Answer in ft/min.

Show the answer

402.5 ft/min

350 x 1.15 = 402.5 ft/min.

Reference: ASME A17.1-2025/CSA B44:25 (rule identical in ASME A17.1-2022/CSA B44:22), Section 2.18

A tech finds an oil buffer that was compressed by a test. Before the car may run again, what must the controls prove?

  1. That the car doors are closed
  2. Buffer has fully re-extended
  3. That the governor has been reset
  4. That the final limit has been jumpered
Show the answer

B. Buffer has fully re-extended

An oil buffer must be proven fully extended, normally by a switch, before the car runs, because a part-compressed buffer could not give its full stroke next time. Doors and governors are separate checks.

Reference: ASME A17.1-2025/CSA B44:25 (rule identical in ASME A17.1-2022/CSA B44:22), Section 2.22

Other topics