10 questions, graded as you go, with the reason for every answer. Start free, no sign-up.
Sample questions
The sill flashing or sill pan under a window should be sloped which way?
Slightly toward the inside
Slightly outward
Level in both directions
Toward the nearest jamb
Show the answer
B. Slightly outward
Any water that reaches the sill must drain outward, so the pan or membrane slopes to the exterior. A level or inward slope lets water pond and enter the wall.
Reference: Red Seal Occupational Standard for Carpenter (2022), exterior finishing tasks
Vinyl siding is nailed in the centre of the slotted holes and not driven tight. Why?
The nails would split the studs
The panel must be able to drain
To allow thermal movement
The nails would rust faster
Show the answer
C. To allow thermal movement
Vinyl moves noticeably with temperature, so the nail head is left slightly proud and the panel can slide. Nailing it tight makes it buckle in heat. The holes are slotted for movement, not for drainage.
Reference: Red Seal Occupational Standard for Carpenter (2022), exterior finishing tasks
A deck ledger is bolted to the house band. Where does flashing go?
Over ledger, under wall barrier
Under the ledger, between it and the band
Only on the end of the ledger
Nowhere, because the ledger is pressure-treated
Show the answer
A. Over ledger, under wall barrier
Flashing over the top and face of the ledger sheds water out over the deck connection, and the barrier above laps it. Treatment protects the wood but does not stop water entering the band joist behind it.
Reference: Red Seal Occupational Standard for Carpenter (2022), exterior finishing tasks