10 questions, graded as you go, with the reason for every answer. Start free, no sign-up.
Sample questions
When hanging drywall on a ceiling with wood joists, how should the sheets normally be oriented?
Long edges parallel to the joists
Long edges across (perpendicular to) the joists
Diagonal to the joists
Any direction as long as the ends land on joists
Show the answer
B. Long edges across (perpendicular to) the joists
Running sheets across the framing gives bearing along each long edge, resists sagging and reduces the number of joints. Parallel sheets have more edges falling between supports.
Reference: Red Seal Occupational Standard, Carpenter (2022): interior finishing and stairs
How deep should a drywall screw be set?
Slightly below the paper surface without breaking the paper
Flush so the head cannot be seen
Deep enough to cut through the face paper
Proud of the surface so mud can cover it
Show the answer
A. Slightly below the paper surface without breaking the paper
A slight dimple lets joint compound fill the head, while unbroken paper keeps the holding power. Breaking the paper lets the screw pull through.
Reference: Red Seal Occupational Standard, Carpenter (2022): interior finishing and stairs
Why is a coped joint usually preferred to a mitre at an inside corner of baseboard?
It always uses less material than a mitre does
It is the only joint type that a nail gun can fasten
It makes the inside corner look softly rounded
It stays tight when walls are out of square or wood shrinks
Show the answer
D. It stays tight when walls are out of square or wood shrinks
A cope fits against the face of the adjoining piece, so an out-of-square corner or seasonal movement does not open a gap the way two mitred ends would.
Reference: Red Seal Occupational Standard, Carpenter (2022): interior finishing and stairs