TradeExamPro

Finish trades safety business practice questions

32 questions from the Interior finish and envelope trades practice test.

Start practising

Finish trades safety business practice test

10 questions, graded as you go, with the reason for every answer. Start free, no sign-up.

Sample questions

Before bidding work in a new city, a painting contractor wants to know if a licence is needed. What is the correct first step?

  1. Assume the home state licence is valid there
  2. Check state and local licensing
  3. Ask the owner, who must know the rules
  4. Start work and apply once the job is awarded
Show the answer

B. Check state and local licensing

Licensing is set by state and local authorities and varies widely, so the contractor should check with them before bidding. An owner is not the authority, and working first can bring penalties and may block collection of payment.

Reference: State and local contractor licensing board rules (vary by jurisdiction)

A flooring contractor installs a floating floor over a slab without testing moisture, ignoring the maker's installation instructions. Which result is most likely?

  1. The manufacturer's warranty is extended for the installer
  2. The installer is released from any workmanship warranty
  3. Warranty voided; installer bears risk
  4. The owner alone is responsible whatever the contract says
Show the answer

C. Warranty voided; installer bears risk

Manufacturer warranties normally depend on following installation instructions, including moisture limits, so ignoring them can void coverage and leave the installer exposed on workmanship claims. The installer is not released just because a product warranty exists.

Reference: Manufacturer installation instructions and warranty terms; contract warranty clause

How often must an employee who wears a tight-fitting respirator be fit tested after the first test?

  1. Every five years
  2. Only when the filter type changes
  3. Every two years
  4. At least once a year
Show the answer

D. At least once a year

Fit testing is required before first use and then at least annually, and again if the face size or the respirator model changes. Waiting longer would let a poor seal go unnoticed.

Reference: OSHA 29 CFR 1910.134(f)(2)

Other topics