Painting coatings practice test
10 questions, graded as you go, with the reason for every answer. Start free, no sign-up.
Start practice test
The practice test needs JavaScript. The sample questions below work without it.
Sample questions
Paint film that lifts into raised bubbles on an exterior wall is most often caused by what?
Using too much thinner in the can Moisture or heat trapped under the film Brushing in the wrong direction Tinting the paint too dark
Show the answer
B. Moisture or heat trapped under the film
Blisters form when moisture vapor or heat pushes the film away from the surface. Brush direction and tint do not cause blistering.
Reference: PDCA coating defect guidance; coating manufacturer troubleshooting guides
During pre-1978 renovation work under the EPA RRP rule, a heat gun used to remove paint must not be operated above what temperature?
600 degrees F 800 degrees F 1100 degrees F 1500 degrees F
Show the answer
C. 1100 degrees F
The rule prohibits heat guns operated above 1100 degrees F because hotter guns create lead fumes. Open-flame burning and torching are also prohibited.
Reference: 40 CFR 745.85(a)(3) (RRP prohibited practices)
For interior RRP work, plastic sheeting on the floor must extend at least how far from the work area?
2 feet 10 feet 20 feet 6 feet
Show the answer
D. 6 feet
The interior rule calls for floor covering extending 6 feet from the area being worked, or farther if the work spreads dust further. Ten feet is the figure used outdoors.
Reference: 40 CFR 745.85(a)(2)(i)